3D Resin Mixer & Heater,3D Printer Resin Heating Box,Efficient Mixing,No Heating or Preheat 40℃,50℃ to Improve Printing Quality for 250g/500g/1kg LCD DLP SLA Resins of Anycubic Elegoo Phrozen

VERY GOOD PRODUCT AND WORKS WELL.

I kept having print failures and I couldn’t figure out why. After grabbing this bad larry I never fail any and the resin doesn’t seem to matter as much anymore.

A novel idea, but poor design. It is starting to cool off, and I decided to give this heater a shot. I kept it on low speed and low heat, since that is really all I needed. I watched it for a few minutes, then closed the lid to let it do its thing. Came back 30 minutes later to a very nice heat, but no rotation at all. Giving the bottle a gentle turn, the motor made an odd noise, rotated about half a turn and then stopped again.Guess I’ll be reaching out to Assurant to handle the warranty on this one.

After running 2 bottles through the unit, the motor no longer turns. Now it's just an expensive heater.

The media could not be loaded. This mixer has two speeds and three temp settings counting no heat. It does work, but I think it’s overpriced for what it is. Right out of the box, the control panel cover was already coming off of mine. It’s just held on with adhesive around the outer edge, which is not enough to hold it as much as the button springs protrude upward. After reattaching, it didn’t make it through a 45 minute test cycle without popping back up. I’ll probably have to use some superglue to get it to stay.The other and main issue is the motor noise. It’s too loud and like fingernails across a chalkboard.

The media could not be loaded. I'm all for any device that helps me get better prints, and in this case saves me the time of shaking in manually to get it mixed. Add in the heating, being able to do something else while the resin is prepared, and this in a win for me.It's hard to say for sure if the heating hits the advertised temps, but since I live in a cold climate anything is an improvement. My one critique is that it's pretty loud, so I'll need to find an out of the way place to let it run. The video makes it seems worse than it is - especially with the lid up - but it gives an idea of what to expect.

Honestly its not terrible but if you have more than one printer the price point on this is going to suck. For this price you can just shake the bottle and sit on it to heat it up lol

I had never seen one of these before, but I can say after getting it and using it, that it is a brilliant device. I used to shake my resin bottles up before pouring them into the vat, which causes tons of air bubbles. This not only mixes, but preheats the resin. Great product!