UniTak3D Ender 3 3D Printer LED Light 24V 7.5W Dual Sides Embedded Light Bar Strip Upgrades for Ender 3 V2,Ender 3 V2 Neo,Ender 3,Ender 3 Neo,Ender 3 Pro,Ender 3 S1,CR6SE,Voxlab Aquila(2020 Profile)

Really handy light upgrade and easy to install. Very bright and able to illuminate the print bed well. You have to print off your own print bracket, which makes it a fun installation. A very useful no-brainer upgrade for price.

I have been after some lighting for my Ender 3 v2 Neo for some time.Fitted this unit, but was wary of opening the power supply as this would throw my level and z offset out (taken me long enough to get it just right)So opted for a 24v 1a plug in converter which came with loads of adapters and a screw terminal option.24V 1A Power Supply Cord 24 Volts Charger £12.99 on AmazonAll working well and the z offset is still fine.I hope this is of help as I was looking at the reviews to see if anyone had tried an external power source.

As it comes this is OK, a bit awkward with the potential for the LED strip sides to get stuck in the inner Z axis wheels, and the power cable can interfere with the outer Z axis wheels if not fitted well. I have a few improvements which make this kit great:1) Cut 10mm wide strips of something opaque like a UK milk bottle, and slide this plastic down the inside of the Z axis at the same time as the LED strip. This keeps the LED strips well clear of the wheels and softens the light.2) Slide the switch into the 3d printed housing from the cable sides, do not attempt to push it in from the top as it is likely to snap the print.3) Cut the power cable mounting strip to the shortest length necessary, it's a pain to feed the cable through more than about 20cm. Mount the power cable on the back of the Z axis frame where the wheels don't run, don't try to feed the cable under the wheels.

The media could not be loaded. These lights are brilliant. Anyone comfy with 3d printing should have the know how to install these. Installation is simple, and they provide excellent light for the entire bed, and below the bed! This is the best mod I've added by a mile.

The media could not be loaded. Happy to see it come with screws for the mount and though it was funny it asks you to 3d print your own button mount.I understand the reason behind and fully support it tho, glad to see a responsible seller.The led strips are full of leds and not those that have wide gaps between leds, if anything it's too powerful so I wish it had an option to dim them so I can keep it on at night when I go to bed.I usually check up on my prints using a torch but with this I don't need to anymore, 100% recommendedInstalation was super easy with the tools my ender 3 already came with, just used a larger screwdriver to remove the power unit from the frame to access the rear 2 screws.

Behold for that which illuminates the printNice bright, I took the top bar off and fed the lights down the channel, ran the cable across the under side of the top bar and fitted the supplied cable cover, you need to take the power supply off the side and put the wires in as per the photos.

Y lights are not to bad. the Solder joints are still weak but if your careful you will be ok.The Hot End light solder joints however, are as much use as a hand break in a Canoe by the looks of it. The package came with the joints already separated. I returned the Item and wont be replacing it as the joints for the hotend light need redesigning before they are good enough to use.Poor show of quality from UniTak

Ok build quality but very basic quality and poor quality control. New main board and heatblock replaced just after use..Good support as needed. Plenty of other brands better at price. Got anycubic kobra neo at same time and no issues.