HiLetgo TB6612 Mosfet for Arduino Motor Shield Standard IIC I2C TB6612FNG Stepper Motor PCA9685 PWM Servo Driver Shield V2 Robot PWM Uno Mega R3 Replace L293D

perfecto

La placa de desarrollo ayuda a trabajar con motores de forma correcta no sufre recalentamiento

Few pins did arrive bent but wasn't much of an issue to set them straight. You do have to be careful and not overly tighten the wire connector cause it will kinda twist when you go too tight. Currently using it to run fans on my sim rig paired with an Elegoo Uno Rev 3 and was able to get my fans running with Simhub. Could have probably been a little cheaper but for what I needed it works for now.

After about 10 minutes of bending and swearing, I finally got all the header pins straightened out. I have only bought a few things from this seller and they all seem to be poorly made. This is the last product I buy from them.

My motor shield came with bent pins and loose ports. If you applied a bit of force to the ports they would wiggle and a little too much force when screwing the wires in could potentially beak them. I was very cautious when using it in order to not completely break the ports and tried to unbend the pins. I will keep it because I need it ASAP for a project but I wouldn't recommend getting these from this seller.

I used this to run a couple large servos. Worked fine.