Creality Official 3D Printer Adhesive Stick Warping Reducing Glue Stick for Hot Bed 3D Printer Bed - PVP Solid 3D Print Glue Stick for PLA/ABS/PETG/PC/PA/TPU (Pack of 1)

I swapped out my old yellow springs for these silicone mounts, and it was a breeze—took me 10 minutes, no tools needed. My Ender 3 V2 bed is now perfectly level, no wobble, and my prints stick like a dream. These things are heat-resistant, super sturdy, and just make 3D printing so much easier. If you’re tired of constantly re-leveling your bed, these are a no-brainer.

My prints kept failing before using this product, and warping would often occur. After using this glue however, almost every single one of my prints has successfully printed, with little to no warping at all. It’s an absolutely brilliant product, worth every penny!

These are shorter than the springs they replace. There is also one that is shorter than the other three and this one has to go in the back left position where the cable fits the bed. However to get enough tension a washer had to be used as a spacer under this one.Once the bed is level and all are under tension the z axis has to be reset by lowering the microswitch until the correct nozzle home position is found.A lot of trial and error but they're far better than the springs once it's all set up.

Works well on my Tina 2.

Fitted to the original, basic Ender 3.These were simple to fit. I followed a video just to make sure.The short one is supposed to be that way and fits with the bed heater bracket.There is one model that the short one doesn't suit, but that is stated in the listing. Just read & check your model.Once fitted, adjustments seem easier, finer and definitely more stable.I can now go back to the printer and just print away. It doesn't move any more.I'm sure it will do over time, but the stock springs and the yellow 'upgrades' both require constant levelling.What's more, they're cheap.

Didn't work well!It was basically an over priced kids glue stick

For something so cheap and simple this is an amazing upgrade.Bought for an Ender 3 S1 Pro, unwind the large plastic spring adjusters until they fall of. Lift up the bed and remove the springs and swap each for an orange rubber spacer. Then again spin the adjuster wheels until they stop. Simple to do and literally takes 5min.Now when auto leveling it always all green with barely any change each time.After reading the reviews I bought the double pack as it appears the S1 needs 4 equal hight spacers and not the 3&1 you get with the bag of 4.

I never thought I would find myself writing a review for bed clips, but here we are! These Creality Official Ender 3 Bed Clips are absolute lifesavers for anyone tired of their 3D prints sliding around on the bed like a drunk penguin on ice. Not only do they keep the print securely in place, but they also add a touch of elegance to my printer bed. My Ender 3 is now dressed in a black-tie outfit and ready to print some serious business. And let's be honest, who doesn't want a printer that looks ready to hit the red carpet? These clips are so easy to install that even my cat could do it (if she had opposable thumbs). So, if you want to take your 3D printing game to the next level and impress all your friends with your stylish and secure printer bed, these Creality Official Ender 3 Bed Clips are the way to go. Just be prepared for all the jealous looks from other 3D printing enthusiasts.