TCMTDetachable Docking Hardware Kit Fit for Harley Deluxe Heritage Classic Softail Slim Fat Bob Low Rider FLDE FLHC FLHCS FLSL FXBB FXFB FXFBS FLSB FXLR FXLRS and Fit for FXST 18-Up

Love this addition to my Softail. I have added a rack to it and they both now come off easily making the natural look easy to achieve when riding one up. Came with two sets of mounting pieces making sure you have the right ones for your ride. Did not come with instructions but pretty self explanatory on how to mount and everything is there to get the task done. Only reason I gave 4 stars instead of 5 is that the rear mount is allowed to move (slightly) and will make a VERY small noise if on rough ground. A couple wraps of hidden electrical tape and its perfect.

I thought the docking hardware was rather expensive for a couple of lugs and some washers and some boats they did work on my bike and I'm glad that I bought them but again all I needed was four of the lugs didn't need any boats I used the same bolts for my saddlebags so I had a lot of hardware left over I didn't even need but this was my first rodeo so I have learned from it but on all I'm pleased I did get my sissy bar attached today been waiting for a while but the wage is over thank you Amazon and whoever the product provider is. With regards Bill Reed

Not exactly harley quality but definitely does what its supposed to

This Standard Sissy Bar Upright Backrest does properly on a FLHC/S Heritage Classic with stock saddlebags. Here’s my experience and things to look out for.1. Remove your saddlebags. On the bag bolts are a black spacer which is held on by a small black “O” ring. Pull or twist the black spacer off a LITTLE to reveal the “O” ring. Once you see it, roll it off the bolt the rest of the way with your fingers.2. Replace the stock black spacers with the supplied docking spacers. Install the all silver docking spacer on the left/front and the black docking spacer on the right/rear. Make sure the left and right docking spacers line up evenly. Mine didn’t. The left spacer sat a little further back than the right spacer. I used a supplied washer to make them even.3: Remember to “roll” the “O” rings back on the bolts. Reinstall the saddlebags.4. Now for the Sissy bar. I could not put the Sissy bar on the docking bolts with the passenger seat on the bike. Take the passenger seat off first.5. Next, I lined up the Sissy bar with the docking spacers, but the Sissy bar mounts were slightly too narrow. With my hands, I was able to “spread” the Sissy bar over the docking spacers, working one side, then the other. It was not that hard to do.6. With the Sissy bar now resting on the docking spacers, MAKE SURE to “snap” the Sissy bar onto the front and then rear docking bar spacers. You should hear/feel the bar snap into place.7. Passenger Seat. You cannot reinstall the passenger seat like you normally would (pointing the front end in first). Slide the passenger seat in sideways (point the front toward the fender), THEN twist and position the seat to the front of the bike on the seat mounts. It’s easy once you do it the first time.8. Install the Sissy bar pad on the bar and you’re done. The fit ie snug and secure.I might have made the install sound harder than it should have been. It really wasn’t. Just trying to point out some of the things you might run into. Enjoy. Ride safe.

Looks great, locking mount a bit loose but already had a mounting bold from luggage rack from different maker