0/2/4 Gauge in 0/2/4 Gauge Out Copper Power Distribution Block for Car Audio Splitter(1 in 2 Out)

I'm using this as a distribution block in my solar setup. It passes hundreds of amps without getting hot at all. The threads didn't strip out when I tightened it proper tight. I have 3 of them in my setup and all 3 work great.I broke one of the plastic covers but that is on me. I dropped it and when it hit the floor one of the clips broke. Learn from me and don't drop it.

I used this to relocate my battery to the rear of the vehicle. Works good for its intended purpose. The only thing that gave me a little trouble was the rubber gaskets around the wire. The rubber rings don't like to stay seated and pop out leaving a slight gap which may lead to corrosion. This is why it gets 4 stars instead of 5.

Worked good but the plastic part breaks easily so be careful where you place it could touch metal and blow your system

Worked great. Only issue was if you are using 0 gauge it's a tight fit and doesn't have much room for jacket.

Worked as it should have worked I do suggest you get wire Farrell so if you use a zero gauge wire and you insert when you tighten up the set screw it does not mess up your wires trust me this combined with the why are ferals

This is the second one I've bought it works as advertised love this product

This is a great product but please make sure you use screws that don't touch the block. It was glowing red and smoking, It's was starting to catch fire by the time I yanked on the wire and it blew the fuse. Great product, just keep that in mind

This product is actually very good! I was somewhat concerned by some reviews, but took a chance on them. I must say way better than a lot of competitors in the same price range and even as good as some in the higher price points. Now for some of the complaints i seen in the reviews. There were a few complaints on the opening sizes being too small for 1/0 wire. In general this is actually kinda normal with lots of distribution blocks, and its a good idea to use adapters in this case. I will say the developers of this product should consider true 1/0 openings though simply because the most intended use for these will be in car audio systems an most likely high powered. My true 1/0 adapters wouldn't fit so i used 1/0 to 4 gauge adapters. Like i said this is the norm alot of the time , but definitely should reconsider using oversized 1/0 openings like amplifiers for true 1/0. Furthermore this product is very solid an don't have the issue some other companies have. Like not being able to get the plastic covers on with adapters. I've had several distro blocks that I had to modify the plastic covers to fit around wire adapters, so even though these may not exept a large 1/0 wire they did take into consideration that the cover would not interfere with wires with adapters. Last i seen some complaints about screw holes being to close to the block. Well simply put that is a non issue when using correct mounting screws. Furthermore no and i mean no distribution block should be mounted to metal in the first place, which was the reviewers complaint. Concern of shorting out by installing to metal, and accidentally touching the block with a screw or screw bit. This is an amateur mistake of an installation not a product problem.

Well Worth the money. High quality all around. Not alot of distribution blocks that have the same in/out size like these. This is perfect for a multi amp installation when keeping your power/ground wires the same size through out the build.And as far as mounting stated by others, You need the CORRECT screws and there will be no worries of metal on metal contact.