EVIL ENERGY 10AN PTFE Fuel Line Kit,AN10 E85 Nylon Braided Fuel Hose 16FT(1/2Inch ID)

Very easy to Install with a nice quality finish. My only complaint is that the line separators provided within the kit were too big and didn't clamp down on the line and stay in place. The fuel line used in this kit has a very thin outer layer, making the diameter smaller than an older style -8AN line. Maybe the -6AN clamps would work?

This things comes with about every option available! Ended up only using one 90 and one straight but great options included. Product seems sturdy and no leaks!!!

Easy kit to use as needed.

Easy to use, instructions a little unclear but a simple YouTube video will give you more than enough information on how assemble everything. Used it for my valve cover to catchcan and my intake to catchcan

Great value for the amount of line and fittings you get. Pressure tested great with no leaks. Wish it was more flexible but I think that’s just how PTFE is!

Here is a quote from the listing,, "Maximum Working Pressure (psi): 3000 psi. Bursting Pressure (psi): 10000psi." This hose was made up for a power steering hose assy that sees max 1100 psi. Started engine and topped off p/s system, started turning wheel left to right for about 10 seconds and lost all assist. Hose burst before the fitting, teflon liner poking out of the braided cover.Discovered the problem, not the fault of the hose. The instructions do not stress how important it is to get the hose braiding as far down into the nut as you tighten it. The nut should be tight all the way down. If it gets easy to tighten that means you are not doing it correctly and the hose will blow apart. I took it all apart and reinstalled a new hose and this time both fittings were tight all the way down, and it is working great as a power steering hose.

The media could not be loaded.  Makes it too easy to make AN lines!

I used this kit for a 73 Bronco's fuel lines with electric fuel pump. Also for the hydro boost braking and power steering which both operate off the power steering pump.Cutting these is the key to an easy install. Tape and USE a CUT OFF WHEEL. Do not fray the S.S. outer layer and expect a good seal.4" grinders are cheap...get 2! 1 for a cutoff wheel and the other for a braided wire wheel.

Lots of fittings and lots of hose. Gotta make sure to jam the hose all the way into the fitting before screwing it together. Great product. If you need AN lines/fittings get this

I bought this and the TT fittings kit off of EBay .... this kit had better machining on the threads and went together nicer. I will update once I get the fuel pumps in and primed..... update.... no leakages.... went together really nice.....

This is not -8an hose this is more like -6an. The hose ID should be 13mm instead I got 10mm, I'm disappointed took over a month to get to me, just a waste of time and money, look elsewhere for the proper stuff

Everything as advertised. Only issue was the two clamps that came with the hose were over sized.

Works great. I used the AN10 ptfe line to run an on board air system for my jeep. The line and fittings are fine. I suspect most of the complaints stems from those with no expierence with these lines. Keep your cuts square and clean and there are no issues.