3D Touch Auto-Levelling Sensor, Auto Bed Leveling Sensor, Touch Smart Sensor For 3D Printers, Improve Printing Precision
Description
- 3D printer touch is an auto-levelling sensor for 3D printers that can precisely measure the tilt of your print surface. It can greatly improve the printing precision of your 3D printer.
- Features: simple, smart and precise. It could work with almost any kind of bed materials, such as glass, wood, metal and so on.
- The main functions and controls of 3D touch printer are the same as most auto bed levelling sensors, which consists of a RC servo and a micro switch, thus, 3D touch printer can be used on almost any 3D printer control board.
- By using progressively designed solenoid and hall sensor, it can integrate high precision in such a simple structure. To make it more user-friendly and to bring you more enjoyable printing experience.
- Pulling/pushing hard on the push-pin can damage the touch sensor and make it less accurate.
Full description not available
Reviews
D**T
Not tested in anger yet, but seems to work very well
Tested this just wired to a new SKR 1.4 board, without actually connecting it to my printer yet (since it's in the middle of a print). It seems to work just like it should, right off the bat. I simply connected the three plugs to the SKR board as described for the BLTouch, flashed the firmware with BLTouch enabled, and was able to run a probe and see the probe popping in and out, etc.I'll update this if there are any problems with accuracy once set up on the printer. So far, it seems like a great, better value option than a BLTouch.
J**N
Very Good. Works well
The device works well.Easy to install.You need to take extra care when lining up and make sure you adjust the Z settings on the printer to lower the head by approx 2mm.If you install and the Extruder dives into the heatbed, Turn off the printer and check the wiring.I had this happen and it was because I had the wires in the right place but they was around the wrong way.
C**R
Didn't even last a week before faut
Returned to Amazon, 6 days after purchasing.Had done about 3 or 4 print runs since getting it last Saturday afternoon, this evening turn it on and it just keeps going to a red flashing light with no changes to the printer being made or touched since last successful print.Rebooted printer several times and in all cases the sensor pin never extends anymore during the self test at startup.Garbage
M**D
Waste of money.
Didn't work. Bought for a new build to keep costs down. Didn't work at all. Tried it on two other printers that both have BLtouch's on and it didn't work on them either. Sending back and buying the real thing.
F**D
Faulty
It is faulty
M**H
thank you
Thank you, all is working well
P**N
Perfect print quality upgrade on my CR-10S
Was a bit fiddly to setup which was expected but there are plenty of guides and people that have upgraded who can help in the 3D printing community. Works exactly as expected and for the price I cannot complain at all.
Common Questions
Trustpilot
3 weeks ago
1 week ago
